当前位置:首页 >> 电子/电路 >>

AM-TX1-433中文资料


元器件交易网www.cecb2b.com

AM RF TRANSMITTER M ODULE.
FEATURES

AM-TX1-XXX

? ? ? ? ? ? ? ? ? ?

MINIATURE MODULE (7.5 x 11.5 X 4.5mm) SAW CONTROLLED FREQUENCY STABILITY NO ADJUSTABLE COMPONENTS. TRANSMITTING RANGE UP TO 30 METRES. CMOS/TTL COMPATIBLE INPUT. CURRENT CONSUMPTION 2.5mA (typ). SINGLE SUPPLY VOLTAGE 2.5 -12V. COMPATIBLE WITH R.F. SOLUTIONS AM RECEIVER. MPT1340 LICENCE EXEMPT. AVAILABLE AS EITHER 418MHz OR 433MHz.

APPLICATIONS
? ? CAR ALARM KEYFOBS REMOTE TRANSMITTER ENCODERS ? ? GARAGE DOOR OPENERS REMOTE GATE SYSTEMS

DESCRIPTION
The R.F. Solutions AM Transmitter module offers a miniature hybrid modular RF transmitter providing on-off keyed modulation, which can be used to transmit data from any standard CMOS/TTL source up to 1200 baud. The module is very simple to operate, requiring only two connections (see application circuit below). The module is also very efficient, using only 2.3mA ( typ) which means that it may be driven directly from an encoder I/C or microcontroller. The output impedance has been designed to give optimum performance when coupled with a small antenna such as a tuned loop or short whip. The modules are compatible with the AM Receiver modules (AM -HRRn-XXX or AM-RRS2-XXX). The transmitter module is type approved to MPT1340 for use in general telemetry and telecommunications products, when used with the antenna as listed overleaf.

APPLICATION CIRCUIT
Driving TX1 from Current Source Signal from Encoder circuit Driving TX1 from - Current Sink

Rd drive current drive Voltage 220pF + TX1 Module RF GND RF GND drive Voltage 220pF TX1 Module

Signal from Encoder circuit

Rd drive current

DS012_1

Oct 00

?2000 REG No 277 4001, ENGLAND.

Page 1

元器件交易网www.cecb2b.com

AM RF TRANSMITTER M ODULE.
Operation

AM-TX1-XXX

The application circuit shows how to drive the module. The module may be driven from either a current source or current sink. In both cases the dropper resistor is required to set the drive current. The maximum and minimum drive voltage for various dropper resistor values is shown below. For other voltages between 2.5 - 13.1V the values may be calculated using the following formula Min Rd = ( Max drive Voltage - 3 ) / 0.0046 The minimum drive voltage for a given resistor value may then be calculated as; Min drive Voltage = 2.2 + .003 * Rd Example: The max drive voltage is 5.5V. The min Rd is therefore 543 ?. The nearest preferred value above this is 560 ?. The min drive voltage with 560 ? is 3.86V.
ANTENNAS

Two types of antenna may be used, a tuned loop, or a short whip. The tuned loop should be driven directly from the module. The whip should be driven via the specified tuning network. The module is not type approved for use with a 1/4 wave or helical type antenna. Tuned Loop Antenna Short Whip Antenna
90mm MAX

~ ~
RF Ground Max 700mm2 1-5pF RF Ground 1-5pF

The tuned loop Ant is constructed from wire of 1-1.5mm DIA, or PCB track of 1.5-2.5mm width. The enclosed area of the loop shall not exceed 700mm2. The trimming capacitor should be used to tune the ant for max output. A 1.5 - 5pF cap is generally adequate.

The short whip ant is constructed from a wire rod or PCB track of 90mm length. The 15nH inductor may be an SOIC component on the PCB, or an air cored solenoid of 0.8mm inside DIA, close wound with 9 turns of 0.56mm. The trimming capacitor should be used to tune the ant for max output. A 1.5 - 5pF cap is generally adequate.

MECHANICAL DETAILS Width = 7mm, Height = 11.5mm, thickness: 4.5mm. +ve connection is shown by marking on body side Lead Pitch 5.08mm.

11.5mm +ve Side 7.5mm 5.08mm

4.5mm

DS012_1

Oct 00

?2000 REG No 277 4001, ENGLAND.

Page 2

元器件交易网www.cecb2b.com

AM RF TRANSMITTER M ODULE.
TECHNICAL SPECIFICATION Absolute Maximums
Voltage + ve to -ve -2.5 to 8.5V Ambient temperature 20deg C Storage Temp -40 to +85o C

AM-TX1-XXX

ELECTRICAL CHARACTERISTICS Module Voltage (@ max drive) Module Voltage (@ min drive) Drive Current (@ max drive) Drive Current (@ min drive) Working Frequency Working Frequency Data Throughput Tuning Tolerance Radiated Power (ERP) (@ max drive V) Modulation Modulation Pulse width Operating Temperature DRIVE VOLTAGE MAX 13.1 9.9 7.6 6.1 5.2 4.5 4.0 3.5 0.5

MIN

417.925

TYPICAL 3.0 2.2 4.6 3.0 418.000 433.92 +/-75 -6.0 ON-OFF

MAX

418.075 1200

DIMENSION V V mA mA MHz MHz baud KHz dBm mSecs

0.8 -10

+40 RESISTOR VALUE (RD) ? 2K2 1K5 1K 680 470 330 220 100 ‘off voltage’

°C

MIN 8.8 6.7 5.2 4.2 3.6 3.2 2.8 2.5 -1

UNIT V V V V V V V V V

LICENCE EXEMPTION
This range of Radio transmitters is approved by the Department of Trade & Industry (D.T.I. Specification MPT1340) in the U.K., and therefore the user requires no radio operating licence in the U.K. Please note however the following requirements to comply with MPT1340; 1. All transmitters shall use integral antennas only. Receivers may use an external or integral antenna. An integral antenna is defined as one which is designed to be connected permanently to the transmitter or receiver without the use of an external feeder. The antenna shall be a tuned loop not exceeding 700mm2 enclosed area, or a whip not exceeding 90mm in length. 2. The equipment in which the module is used must carry an inspection mark located on the outside of the equipment which is clearly visible. It shall state “MPT1340 W.T. Licence Exempt”. The minimum dimensions of the mark shall be 10 x 15mm and the figure height shall be not less than 2mm.

PART No AM-TX1-418 AM-TX1-433

DESCRIPTION Transmitter Module 418MHz Transmitter Module 433MHz

Should you require further assistance, please call; R. F. Solutions Ltd., Unit 21, Cliffe Industrial Estate, South Street, Lewes, E Sussex, BN8 6JL. England. Tel +44 (0)1273 898 000. Fax +44 (0)1273 480 661. Email sales@rfsolutions.co.uk http://www.rfsolutions.co.uk
RF Solutions is a member of the Low Power Radio Association.
Information contained in this document is believed to be accurate , however no representation or warranty is given and no liability is assumed by R.F. Solutions Ltd. with respect to the accuracy of such information. Use of R.F.Solutions as critical components in life support systems is not authorised except with express written approval from R.F.Solutions Ltd.

DS012_1

Oct 00

?2000 REG No 277 4001, ENGLAND.

Page 3


赞助商链接
相关文章:
全新USB 3.0Type-C接口工作原理
全新USB 3.0Type-C接口工作原理_计算机软件及应用_IT/计算机_专业资料。USB ...而 DP 有 lane0-3 四组差分信号,Type-C 有 RX/TX1-2 也是四组差分信号...
细谈USB TYPE-C_图文
细谈USB TYPE-C_计算机硬件及网络_IT/计算机_专业资料。细谈 USB Type-C 自从...而 DP 有 lane0-3 四组差分信号,Type-C 有 RX/TX1-2 也是四组差分信号...
IOT-NODE433开发套件(GAINS3-433M)
中文手册、CC1000 中文版、编程器使用说明等 文档及光盘资料 用户使用说明书 节点测试用文件:提供了测试节点完整性的可执行文件 传感器板和 IOT-NODE433 节点等...
nrf905中文资料
NRF905 433mhz 接收发射芯片中文资料(附 c 程序) 接收发射芯片中文资料( 程序...当一个包含正确地址和数据的数据包被接收到后,地址匹配(AM)和数据准备 好(DR...
EDTA-Cu01中文
百度文库 专业资料 人文社科 法律资料1/2 专题推荐...EDTA-Mn01中文 EDTA-4Na固体中文 1/2 相关文档推荐...2H2O 分子量:M=433.77 CAS 号:14025-15-1 ...
最新nrf905中文资料-1.doc
NRF905 433mhz 接收发射芯片中文资料(附 c 程序) 接收发射芯片中文资料( 程序...当一个包含正确地址和数据的数据包被接收到后,地址匹配(AM)和数据准备 好(DR...
STM32F407VGT6芯片管脚功能定义_电子/电路_工程科技_专业资料
6芯片管脚功能定义_电子/电路_工程科技_专业资料。...二、串口 TX1/RX1 模式说明: 从机模式:J50=2+3...最新最全的IC手册,包括绝... 138页 1下载券 LM...
韩国三荣AIS SI-30(中文操作)
韩国三荣AIS SI-30(中文操作)_信息与通信_工程科技_专业资料。PETET船长上传文档 文档贡献者 pengppgreat 贡献于2013-08-02 1/2 相关文档推荐 ...
BTS3012单板介绍_计算机硬件及网络_IT/计算机_专业资料
基站 BTS-3012 面板资料 谢家庄(A2)基站专用 大同通信车间 BTS3012 单板介绍单机柜配置数量 说明 子系统 单板 中文名称 英文全称 满配置 基站公共 子系统 DTMU ...
NSC2200E通信及数据处理装置使用说明书
处理装置使用说明书_信息与通信_工程科技_专业资料。...Tx1+ NC Tx1NC Rx1+ DATA1+ Rx1DATA1Tx2+ NC ...(图 3.2) ,在新建工程对 话框中输入工程中文名...
更多相关标签: